Suitable only for Series 2 models from March 1958 to December 1959. Phosphate Coated Finish: For identification purposes, this version of the Series 2 bulkhead features the following: * Holes for \'screw\' type vent controls. * Holes in footwells for early dipswitch with rear wiring. * Holes for \'bolt on\' door check tubes. * Angled tie rod brackets. * Right hand Bonnet Hinge with locating lug. * Holes for voltage regulator mounting plate. * No access hole for clutch slave cylinder bleed nipple. * Return lip along top to retain wndscreen weather seal. * Holes for Round Heater option. * Lower auxiliary panel for hand throttle, choke, diesel engine stop etc. * Seperate wiper motors for driver and passenger are fitted to windscreen. * Captive nuts and cages for wing (fender) fastening. * Captive nut plates for door hinge fastening.