"Suitable only for Series 2 models from January 1960 to c. May 1960. Phosphate Coated Finish: For identification purposes, this version of the Series 2 bulkhead features the following: * Holes for 'screw' type vent controls. * Later dipswitch with wiring to the side. * Holes for 'bolt on' door check tubes. * Angled tie rod brackets. * Right hand Bonnet Hinge with locating lug. * Holes for voltage regulator mounting plate. * Access hole for clutch slave cylinder bleed nipple. * Return lip along top to retain wndscreen weather seal. * Holes for Round Heater option. * Lower auxiliary panel for hand throttle, choke, diesel engine stop etc. * Seperate wiper motors for driver and passenger are fitted to windscreen. * Wings (fenders) secured with Spire nuts and screws. * Captive nut plates for door hinge fastening."